See what makes Strittmatter Heating & Air and Plumbing your number one choice for Ductless Mini Split repair in Highland Village TX.
You and your family can rest assured knowing that Strittmatter Heating & Air and Plumbing is on the job.

Strittmatter Heating & Air and Plumbing is your #1 choice for all your heating, cooling and plumbing repairs in the Denton County Area, TX area.

See what makes Strittmatter Heating & Air and Plumbing your number one choice for Ductless Mini Split repair in Highland Village TX.

Installing Insulation on an Electric Hot Water Heater

Installing an Insulation Blanket on an Electric Water Heater

Note: Installation is more difficult on gas and oil-fired heaters. Ask a qualified HVAC contractor for instructions.

  1. Cut the tank top insulation to fit around the piping at the top of the tank. Tape the cut section closed after the top has been installed.
  2. Fold the corners of the tank top insulation down and tape to the sides of the tank.
  3. Position the insulating blanket around the circumference of the tank. For ease of installation, position the blanket so that the ends do not come together over the access panels in the side of the tank. Some tanks have only one access panel.
  4. Secure the blanket in place with the belts provided. Position the belts so they do not go over the access panels (Figure 2). Belts should fit snugly over the blanket but not compress it more than 15% to 20% of its thickness. The installation is easier with two people. If working alone, use tape to hold the blanket to the top until you get the belts into position.
  5. If your water heater has the temperature/ pressure relief valve and the overflow pipe on the side of the tank instead of on the top, install the blanket so these items are outside of the blanket. Depending on the piping arrangement and location, you may need to compress, or even cut, the blanket.
  6. Locate the four corners of the access panel(s). Make an x-shaped cut in the insulating blanket from corner to corner of each access panel.
  7. Fold the triangular flaps produced by the cuts underneath the insulating blanket. Repeat steps 6 and 7 for the rating/instruction plate.
  8. The blanket must not be installed on a leaking tank.

© Online-Access

 
STRITTMATTER HEATING
& AIR AND PLUMBING
3309 Fort Worth Dr, Denton, TX 76205
2604 Long Prairie Rd Suite 300-3, Flower Mound, TX 75022
2340 Justin Rd #100A, Highland Village, TX 75077
Hours: Monday - Sunday: 7:00AM - 8:00PM
License: Licensed by the Texas State Board of Plumbing Examiners - Master Plumber Abraham DeLarosa M38826. Regulated by the Texas Department of Licensing & Regulation - TACLB7155E.
 
 
STRITTMATTER HEATING
& AIR AND PLUMBING
3309 Fort Worth Dr, Denton, TX 76205
2604 Long Prairie Rd Suite 300-3, Flower Mound, TX 75022
2340 Justin Rd #100A, Highland Village, TX 75077
Hours: Monday - Sunday: 7:00AM - 8:00PM
License: Licensed by the Texas State Board of Plumbing Examiners - Master Plumber Abraham DeLarosa M38826. Regulated by the Texas Department of Licensing & Regulation - TACLB7155E.